Filter
Top Products
Step 2: Cabinet Preparation
ELECTRICAL SUPPLY, DUAL FUEL RANGES
Installation of the range must be planned so that rough-
in of junction box for the receptacle or conduit connec-
tion will allow maximum clearance to the rear of the
unit.
When the power supply cord or conduit is connected
to the mating receptacle or junction box cover, the
combined plug/receptacle or junction box cover/con-
duit connector should protrude no more than 1 3/4"
from the rear wall. See Figure 3B.
7
FIG. 3B Wall Connection
Power Cord & Receptacle
Junction Box & Conduit
1 3/4"
1 3/4"
Note:
When using a 240VAC recep-
tacle having its own housing, it
will be necessary to recess the
receptacle's housing into the rear
wall. Mount the receptacle se-
curely to a wall stud, then seal
around the receptacle's housing.
Follow all local electrical codes.
Refer to Figure 8 on page 14 for location of junction
box on unit. To minimize binding when the unit is
connected to the receptacle or junction box, orient the
receptacle or conduit connector, and slide back into
position.
Note: Canadian models (numbers ending in "CC")
have power cord supplied with range.