Filter
Top Products
14
Step 6: Electrical Requirements, Connection & Grounding
Chart B: Electrical Supply Circuit Requirements
MODEL NUMBER VOLTAGE CIRCUIT RATING FREQUENCY PHASE
PG304 120 VAC 15 Amps 60 Hz. Single
PG366 120 VAC 15 Amps 60 Hz. Single
PG364GL 120 VAC 15 Amps 60 Hz. Single
PG364GE 120 VAC 20 Amps 60 Hz. Single
PG486GL 120 VAC 15 Amps 60 Hz. Single
PG486GE 120 VAC 20 Amps 60 Hz. Single
PG484GGE 120 VAC 20 Amps 60 Hz. Single
• Prior to servicing appliance, always disconnect
appliance electrical supply cord from wall recep-
tacle.
CAUTION
The appliance must be isolated from the gas supply piping system by closing its individual manual shut-
off valve during any pressure testing of the gas supply piping system at test pressures equal to or less
than 1/2 psig (3.5kPa.).
The appliance and its individual shut off valve must be disconnected from the gas supply piping system
during any pressure testing of the system at test pressures in excess of 1/2 psig (3.5kPa.).
When checking the manifold gas pressure, the inlet pressure to the regulator should be at leas 6.0" (14.9
mb) W.C. for natural gas or 11.0" (27.4 mb) for propane.
Do not attempt any adjustment of the pressure regulator.
• For the PG All Gas Ranges, a neutral supply wire
must be provided from the power source (breaker/
fuse panel) because critical range components,
including the surface burner spark reignition
modules, require 120 VAC to operate safely and
properly. An improper 120 VAC power supply will
cause malfunction, damage to this appliance,
and possibly create a condition of shock hazard.
If the correct power supply circuit is not provided,
it is the responsibility and obligation of the in-
staller and user to have proper power supply
connected. This must be accomplished in accor-
dance with all applicable local codes and ordi-
nances by a qualified electrician. In the absence
of local codes and ordinances, the power supply
connection shall be in accordance with the Na-
tional Electrical Code.
• Observe all governing codes and ordinances
when grounding. In the absence of these codes
or ordinances observe National Electrical Code
ANSI/NFPA No. 70 current issue.
• Electric wiring diagrams and schematics have
been placed in the toe kick area of the range for
access by a qualified service technician.
IMPORTANT
For all gas range models with electric griddle (PG364GE, PG486GE, and PG484GGE), dedicated 20
AMP service is required for proper operation.