Thermador PG36 Range User Manual


 
16
Step 8: Door Installation
CAUTION
The door is heavy and requires two people to
handle it properly.
Hinge Locking Pin
Height adjusting screw
Bottom of Door
Photo B. Insert the door hinge into the hinge
pocket in the front frame.
FIG. 15
FIG. 16
Photo D
Photo C
(Retain for future
door removal)
1. Insert the door hinge into the hinge pocket in the
front frame. When the door is properly installed,
the bottom edge will be parallel to the front of the
range and the hinge will click into position and
support the weight of the door.
2. Tip the door parallel to the floor to free the hinge
locking pin.
3. Carefully remove the pins. The door is now free to
close. Install the hold down bracket. Do not tighten
screw.
Retain pins for future door removal.
4. Adjust the door height so the latch lock lever and
spacer gauge enters the slot in the door liner as
the door is closing and the top of the door should
be parallel to the bottom of the control panel.
Tighten down screw on hold down bracket.
5. Oven door hinges seated and hold down bracket
is located in proper locked position. Now the door
opens and closes properly.
6. The toe kick panel should be mounted last to
prevent damage by the door.