Filter
Top Products
STEP 4: INSTALLING ANTI-TIP DEVICE
STEP A: Determine the best location for Anti-
Tip Channel Mounting Bracket. The bracket
may be mounted to the wall or floor behind
the range, offset from side wall as indicated
in the chart below and in Figures 14 and 15:
Model No. "A", Min. "B", Max.
PRDS304 5-1/2" 16-1/2"
PRDS36 6-1/2" 13-1/2"
- For Model PRDS304, the dimensions
shown are from the left side wall only.
- For Model PRDS36, the dimensions
shown are from either the left or right
side wall. Locate the bracket on the
side of the range that will not interfere
with the gas supply line, electrical
wiring, conduit or any other item.
- Select either the rear wall or the
floor for mounting the bracket,
based upon which will provide the
greatest holding strength.
MOUNTING FLANGE OF THE ANTI-TIP
BRACKET, AND THE ADJUSTABLE
MOUNTING CHANNEL MUST BE AT-
TACHED TO THE APPROPRIATE MOUNT-
ING HOLE. REMOVE ANY LOOSE ITEMS
SUCH AS GRATES AND BURNER CAPS
FROM THE TOP OF THE RANGE, THEN
CAREFULLY TILT THE RANGE FORWARD
TO ENSURE THAT THE ANTI-TIP DEVICE
STEP H: Using the 1/4"-20 x 1/2" Hex Head
Bolt, Hex Nut and two (2) Flat Washers,
securely attach the Adjustable Anti-Tip
Channel to the existing hole in the flange
located at the bottom rear of the range.
(There are two (2) holes in the range flange,
so be certain to select the hole that is on the
same side as the mounting bracket.) The
flat face of the channel should be flush
against the underside of the range flange.
From the bottom of the channel, screw the
two (2) #10 x 1/2" Phillips Screws up
through the first pair of holes extending
beyond the rear edge of the range flange.
These screws will prevent rotation of the
channel. Note: A number of mounting
holes are provided in the Adjustable
Anti-Tip Channel. Be certain to use
the hole that enables the channel to
engage the mounting bracket when the
range is in its final installed position.
For ranges that are to be installed flush
against a rear wall, use the first hole in
the Adjustable Anti-Tip Channel, such
that the short portion of the channel
extends out from the bottom of the
range flange and the long portion is
hidden beneath the range. Refer to
Figure 10.
STEP I: Carefully slide the range into posi-
tion. FOR THE ANTI-TIP CHANNEL TO
ENGAGE THE MOUNTING BRACKET, THE
REAR EDGE OF THE RANGE SIDE PANEL
MUST BE WITHIN 2" OF THE VERTICAL
ENGAGES TO PREVENT TIPPING.
PRDS304 AND PRDS36 Dual-Fuel Ranges (Figures 11, 14 and 15)
PRG304: 2-3/4"
PRG36: 4-5/8"
May Be Used On Either Left
or Right Side (Right Shown)
SIDE VIEW
FIG. 13 PRG36 Floor Mount
PLAN VIEW
➝
Anti-Tip Channel
➝
Mounting Bracket
➝
➝
➝
Mounting Bracket
Anti-Tip Channel
Leveling Leg
Page 13