Filter
Top Products
• The range has an approximate
shipping weight as shown in
Chart A. It is recommended that
the door(s), grates, burner caps,
front kick panel and oven racks be
removed to facilitate handling.
This will reduce the weight as
shown in Chart A and allow the
range to pass through 30" door-
ways. See Chart B and Fig. 2a and
2b. Do not remove the grill or
griddle assemblies.
• Remove the outer carton and
packing material from the ship-
ping base. Remove the front kick
panel (see Fig. 4) by removing two
(2) screws at the top and pulling
forward. The dual fuel ranges are
held to the skid by four (4) bolts,
the front two (2) are behind the
kick panel (see Fig. 4) and the
rear two (2) are located on the
bottom flange of the range back
(see Fig. 5). All-gas ranges are
held in place by 4 bolts, two (2)
as shown in Fig. 4 and two (2) at
the rear as shown in Fig. 5. After
removing the bolts the range
must be lifted and removed from
the skid.
• To remove the door, open the
door to the fully open position.
Close the hinge latches (See Fig.
6) by rotating towards the door
top. The door can then be re-
moved by gently lifting and
pulling the door, with the hinges
up and out of the frame. Do not
lift the range by the door
handle(s).
Chart A 30" Range 36" Range 48" Range
Shipping Weight 335 lbs. 444 lbs. 584 lbs.
Weight without 285 lbs. 390 lbs. 524 lbs.
packing materials
After removing door(s), 215 lbs. 295 lbs. 395 lbs.
burner caps, front kick
panel and oven racks
Chart B 30" Range 36" Range 48" Range
Doorway Width Required 28-7/8" 30-7/8" 30-7/8"
(Unit Assembled)
Doorway Width Required 27-3/4" 29-1/2" 29-1/2"
(Oven Door(s) Removed)
Proper equipment and
adequate manpower must
be used in moving the
range to avoid damage to
the unit or the floor. The
unit is heavy and rests on
adjustable steel legs.
CAUTION:
FIG. 4 All Ranges – Removal of
Kick Panel and Two Front
Shipping Bolts
FIG. 5 All-Gas and Dual Fuel
Ranges –Removal of Two Rear
Shipping Bolts
➛
Left Rear
Shipping
Bolt
Front
Kick
Panel
FIG. 6 All Ranges –
Door Removal
STEP 3: UNPACKING, MOVING AND PLACING THE RANGE
Hinge Clip In
Locked Position
Lower Clip After
Replacing Door
Hinge Latch
Page 8