Filter
Top Products
7. If the cooktop will be used with an LP cylinder,
follow these steps:
A. The Model LPHose is available at your
Thermador dealer.
B. This assembly can also be purchased locally
providing it meets the following specifications:
Hose length to be 24".
Regulator must be a high pressure, high volume
unit capable of supplying adequate gas flow
based on the input rating of the unit (refer to
Gas Consumption in Section 2).
The inlet connector on the LP regulator must
be compatible with the LP cylinder valve.
The hose and regulator assembly must be AGA
certified for use with LP gas in an outdoor
application.
C. Install a 1/2" NPT coupling at the end of the
manifold located at the left rear bottom of the
cooktop. Use a pipe sealant approved for use
with LP gases on all threads.
D. Attach gas regulator hose assembly to the
coupling as shown in Figure 10, right.
E. Connect the gas regulator assembly to the LP
tank valve.
F. Turn on the gas supply but do not attempt to
light any burner. Check the unit for leaks per
the instructions in Section 6.
SECTION 5:
UNPACKING
AND
PLACING
THE
UNIT
FIGURE 10
Coupling 1/2" NPT fitting
threading compound on
these threads must be
resistant to LP gas
L.P. Regulator hose
assembly 10" W.C.
Type 1 Regulator
➞
L.P. Tank
(Type 1)
Main
Valve
➞
Regulator Adapter
➞
➞
➚
Bottom of
unit
➞
➚
➚
Collar
10