Filter
Top Products
GAS AND ELECTRICAL HOOK-UP
With the unit inside of the enclosure, connect the
gas supply hose to the manual shut-off valve and
open valve. Check the connection points at the
shut-off valve for any leaks and repair prior to
installation of the unit. See Figures 11 and 12.
Connect the power supply cord to the electrical
supply outlet.
Figure 12 Leak Test Points – Plumbed Gas Supply
SECTION 6: TEST AND ADJUSTMENT
Figure 11 – Leak Test Points
– LP Cylinder Gas Supply
Leak Test Points
Check hose
for signs of
abbrasions,
cracks or leaks
➞
➞
Bottom of Unit
LP Tank
Leak Test Points
Tank
Valve
Regulator
Assembly
CHECKING FOR LEAKS
All points of connection to the gas supply should be
checked for leaks at time of installation or anytime
you smell gas. It is also advisable to recheck them
periodically. Follow the steps outlined below:
A. Make a soap solution of one part liquid detergent
and one part water.
B. Make sure all controls are in the "OFF" position.
Turn on the gas supply to the unit. Use a spray
bottle, brush or rag to apply the solution to all
fittings and points of connection from the supply
stub out up to and including the inlet to the
manifold. See Figures 11 and 12. Bubbles will
form where a leak exists.
C. If a leak is present, shut off the gas at the supply.
Tighten any leaking fittings, turn on the gas and
recheck.
11