10
10. After allowing the coffee grounds to cool, carefully remove
and discard the used coffee grounds and filter.
WARNING: Brewed coffee and grounds, both in the
Removable Filter and Carafe are very hot! Handle with care to
avoid scalding. If Removable Filter overflows, or if the
Removable Filter fails to drain the coffee into the Carafe
during the brew cycle, do not open or handle the Swing-Out
Filter Holder and Removable Filter. Turn the Control Dial to
“FILL”, unplug the coffee maker and wait for the contents to
cool before opening.
Draining Your Coffee Maker for
Transport or Storage
The Water Chamber in your coffee maker should be emptied
whenever the coffee maker will be transported, or stored for
extended lengths of time.
WARNING: The coffee maker is very heavy. Use caution when
draining the chamber.
1. Turn the Power Switch to Off and unplug the coffee maker
power cord from the power outlet.
CAUTION: TO PREVENT INJURY DO NOT ATTEMPT TO
DRAIN THE UNIT UNTIL THE WATER IN THE WATER
CHAMBER HAS COOLED. THIS WILL TAKE SEVERAL
HOURS.
NOTE: To shorten the length of time required for the water to
cool, the hot water in the Water Chamber can be flushed out
and replaced with cold water. To do this:
a. Turn the Power Switch Off and unplug the unit from the
power outlet.
b. Using 10 cups of cold water follow the instructions for
“Brewing” section. While performing this procedure do
not use a filter or coffee grounds.
c. Repeat the 10 cup brewing process at least three times
to ensure that the hot water in the chamber has been
replaced with cold water.
2. Turn the Control Dial to “FILL.”
3. Remove the Removable Filter and Swing-Out Filter Holder.
MERB10B rev 1/21/05 9:26 AM Page 10