Filter
Top Products
8
NOTE: Adding more water than the amount specified may
cause water to flow from the Removable Filter. If this occurs,
replace the Carafe under the Swing-Out Filter Holder or use a
separate container to collect the excess water. Make sure all
excess water has been collected and carafe has been
emptied before moving on to the next step.
9. Plug the power cord into a working 120 Volt AC power outlet
and press the Power Switch. The Power Indicator Light will
illuminate while appliance is On.
NOTE: The coffee maker is designed to remain plugged in
with the Power Switch turned On except during those times
when your coffee maker is emptied for transport or storage or
during times when it will not be used for several days.
10. Wait 20 minutes to allow the water in the Water Chamber to
reach the proper brewing temperature.
You have completed the one-time set-up procedure and are ready
to use your coffee maker to brew fresh, hot, delicious tasting coffee.
For step-by-step instructions please read the “Brewing” section
below.
Brewing
Make sure that you have completed the initial set-up before
brewing.
1. Set the Control Dial to “FILL.” This setting prevents the water
from entering the Water Chamber and allows time for the
Carafe to be placed in position before starting the brew cycle.
FIGURE B
MERB10B rev 1/21/05 9:26 AM Page 8