Filter
Top Products
6
Coffee Maker Features
and Benefits
The one-time initial set-up of the coffee maker (see “Before Using
Your Momentum Coffee Maker,” page 7) prepares the coffee maker
by filling the Water Chamber completely full of water and allowing
time for the water to heat to proper brewing temperature. After this
one-time set-up is completed, each time you brew a pot of coffee
the cold water you pour into the coffee maker pushes out an equal
amount of pre-heated hot water from the Water Chamber. The hot
water flows over the coffee grounds and produces a fresh, hot pot
of coffee. The cold water you just poured in remains in the Water
Chamber where it is heated in preparation to brew the next pot!
10-Cup Brewing Capacity - The coffee maker is designed to
brew 6 to 10 cups of coffee at a time.
Removable Filter - The Removable Filter pulls out for fast and
easy cleaning and filling.
Non-Stick Warming Plate - This feature allows you to keep
your coffee hot after brewing. The non-stick coating prevents the
Carafe from sticking to the surface of the Warming Plate.
To avoid damaging the Carafe, the Warming Plate On Switch must
be turned Off when the Carafe is empty or when the coffee maker
is not in use.
ON/OFF Power Switch - Allows you to turn off the power to the
Water Chamber if the coffee maker will not be used for a few days.
NOTE: The coffee maker is designed to remain plugged in with the
Power Switch turned On except during those times when your
coffee maker is emptied for transport or storage or during times
when it will not be used for several days.
If the coffee maker has been unplugged or the Power Switch turned
Off for longer than a few hours it will take approximately 20 minutes
after the unit is plugged back in and the Power Switch turned On to
reheat the water supply to the proper temperature for brewing.
If the coffee maker has not been used for 3 or more days, it is
recommended that the Water Chamber be emptied and replaced
with fresh water.
MERB10B rev 1/21/05 9:26 AM Page 6