Filter
Top Products
8
Close
1. Switch the switch to the OFF (O) position.
The fan will remain in operation to allow the toaster
to cool.
2. After the fan stops, switch the circuit breaker/fused
disconnect to the OFF (O) position.
3. Cleaning the Peel and Lower Deck
CAUTION - HOT SURFACES
DO NOT TOUCH HOT SURFACES ON
THE TOASTER. DO NOT REACH INTO THE
TOASTING CHAMBER UNTIL THE UNIT HAS
COOLED THOROUGHLY.
a. Remove the lower deck from inside the
toaster. To remove the lower deck:
Pull the door handle forward to open the
door.
Lift the front edge of the lower deck, and
then pull it forward and out of the toaster.
See Figure 6.
Release the door handle.
b. Wash the peel and the lower deck using a hot
solution of McD All Purpose Concentrate
(APC) (HCS). If necessary, scrub these com-
ponents using a McD No Scratch Pad to re-
move discolorations.
c. Rinse the peel and lower deck thoroughly.
d. Immerse the peel and lower deck in McD Sink
Sanitizer Solution (HCS). Use 1 pack of so-
lution for 10 gallons of water.
e. Remove the parts from the sanitizer solution,
and allow them to air dry.
4. Cleaning the Toaster
WARNING
WHEN CLEANING THE TOASTER,
NEVER APPLY ENOUGH LIQUID TO STAND IN
PLACE ON THE UNIT. DO NOT SPRAY, RINSE,
OR SUBMERGE THE TOASTER. EXCESSIVE
MOISTURE IN THE UNIT WILL CAUSE A SE-
VERE ELECTRICAL HAZARD AND MAY OTH-
ERWISE DAMAGE THE TOASTER.
CAUTION
DO NOT clean your toaster using abrasive clean-
ers or pads. Both will scratch and dull the finish.
a. Thoroughly clean the fan (on the back wall of
the toaster) using a stiff nylon brush. See Fig-
ure 7.
CAUTION
The fan must be cleaned regularly. If the fan
is blocked or plugged, bakery products will not
be properly toasted and the toasters interior
components may be damaged.
b. Wipe the exterior of the toaster with a clean,
sanitized towel dampened with a hot solution
of McD All Purpose Concentrate (APC)
(HCS), as drawn from the sink proportioner.
c. Wipe the exterior of the toaster with a clean,
sanitized towel dampened in water to remove
any residual foreign material or cleaning so-
lution. Ensure that all visible moisture has
been removed from the unit.
d. Allow the exterior of the toaster to air dry.
5. Replace the lower deck inside the toaster.
6. Store the peel in a clean, dry location underneath
the toaster.
7. Pull the door handle forward to open the door.
Check that the back side of the door is slippery to
the touch. If necessary, apply a thin coating of
McD Bun Toaster Release Agent (HCS) to the
back side of the door using a paper towel.
Figure 7 - Cleaning the Fan
Figure 6 - Removing the Lower Deck
1. Pull door
handle forward
2. Lift front
edge of
lower deck
3. Pull lower
deck forward
4. Release
door handle