Filter
Top Products
ii
SAFETY INSTRUCTIONS
Grounding Instructions
This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric
shock by providing an escape wire for the electric current. This oven is equipped with a cord that has a ground-
ing wire with a grounding plug, which must be plugged into an outlet that is properly installed and grounded.
Consult a qualified electrician or serviceman if uncertain about the ability to
follow grounding instructions or if doubt exists as to whether the appliance is properly grounded.
X
use an extension cord. If the power cord is too short, have a qualified electrician or
serviceman install an outlet near the appliance.
WARNING: Improper grounding can result in risk of electric shock.
Power Cord Replacement or Removal
If the power cord is damaged, it must be replaced by the manufacturer, its service agent, or a similarly
qualified person.
WARNING: If the plug is removed during service or maintenance, the plug must remain accessible
to the user and within proximity to the oven.
Precautions to Avoid Possible Exposure to Excessive Microwave Energy
(a) Do not attempt to operate this oven with the door open since open-door operation can result in
harmful exposure to microwave energy. It is important not to defeat or tamper with the safety
interlocks.
(b) Do not place any object between the oven front face and the door or allow soil or cleaner residue to
accumulate on sealing surfaces.
(c) Do not operate the oven if it is damaged. It is particularly important that the oven door close
properly and that there is no damage to the: (1) Door (bent), (2) hinges and latches (broken or
loosened), (3) door seals and sealing surfaces.
(d) The oven should not be adjusted or repaired by anyone except properly qualified service personnel.
RF Interference Considerations
The Sota (model NGO) oven generates radio frequency signals. This device has been tested and was determined
to be in compliance with applicable portions of FCC part 18 requirements and to the protection requirements of
Council Directive 89/336/EEC on the approximation of the laws of the Member States relating to electromagnetic
compatibility at the time of manufacture. However, some equipment with sensitivity to signals below these limits
may experience interference.
If your equipment experiences interference:
a
Increase the physical separation between this oven and the sensitive equipment.
a
If the sensitive device can be grounded, do so following accepted grounding practices.
a
If battery-powered microphones are being affected, ensure that the batteries are fully charged.
a
Keep sensitive equipment on separate electrical circuits if possible.
a
Route intercom wires, microphone wires, speaker cables, etc. away from the oven..
Equipotential Bonding Symbol
This symbol identifies the equipotential bonding stud. It is used in banks of appliances to keep them
at the same potential.