Filter
Top Products
2075DWRR
The temperature controller is located in the top drawer. The LED display shows the temperature set point
and is calibrated in degrees Fahrenheit. The controller is factory programmed for a set point of 38°F which
will show when the unit is first powered-up.
To display actual temperature, press the “WARMER” button momentarily. A solid status indicator light (1)
will show the air temperature reading in the cabinet for approximately 10 seconds.
To adjust the temperature set point, press the “SET TEMP” button momentarily; the display will flash. Press
the “WARMER” or “COOLER” button as desired to change the set point. When the desired set point shows
on the display, wait 10 seconds and the new set point will be saved. Wait 24 hours for the temperature to
stabilize before checking the actual temperature again. The temperature range is 34°F to 45°F.
Indicator light status
LED Status Indicates
1•Solid • Compartment temperature displayed
• Flashing • Not Applicable
2•Flashing • Open Thermistor
SET
SET
TEMP
TEMP
WARMER
WARMER
COOLER
COOLER
CLRCO011B
1 2
2075DWRR
13
Design
■
Features
■
Performance