Filter
Top Products
02/2005 3 www.U-LineService.com
™
CO2075DWR — Ice Maker/Refrigerator
General Precautions
Use this appliance for its intended purpose only and
follow these general precautions along with those listed
throughout this guide:
WARNING
SHOCK HAZARD — Electrical Grounding Required.
• Keep the unit unplugged throughout installation
except during testing.
• Never remove the round grounding prong from
the plug and never use a two-prong grounding
adapter.
• Never use an extension cord to connect power to
the unit.
• Always keep your working area dry.
WARNING
The Anti-Tip Kit must be installed on this unit
before it is used. Never use the drawers as steps
or as a shelf to support more than the drawers’
contents. Serious personal injury could occur.
CAUTION
• Use care when moving and handling the unit. Use
gloves to prevent personal injury from sharp edges.
• Do not lift the unit by the drawer handle.
• Do not install the unit behind closed doors or in any
way that would obstruct airflow to the front grille,
which may cause the unit to malfunction.
You have received a carton containing your CO2075DWR
Combo Drawer Model Ice Maker/Refrigerator with a
package inside containing a User Manual, a Product
Registration Card, water connection parts and Anti-Tip
Kit. Complete and mail the Product Registration Card or
register online at www.U-LineService.com. Once your
unit is installed, keep the User Manual and this
Installation Guide in a safe place for future reference.
Your unit is Black or Stainless Steel. Black units have
drawers with top handles designed for the installation of
full overlay drawer panels. When full overlay panels will
not be used, replacement handles MUST be installed (part
number 11926-4-BLK). Stainless Steel units have drawers
with seamless full wrap stainless steel fronts (that do
not accept custom panels), sculpted stainless steel handles
and black vinyl-clad cabinets. Please carefully follow the
directions that apply to your unit and your intended
design.
Tools/Materials Required
• Wrenches
• Screwdrivers — slotted and Phillips head
• 1/4-inch OD copper tubing and shut-off valve for water
supply line
• 1/4-inch thick drawer panel material and cutting tools
(Black units)
• 3/4-inch thick drawer panel overlay material, cutting
tools, drill and bits (Black units)
Inspection
Unwrap and inspect the unit on a flat, level surface
capable of supporting its entire weight.
Removing Protective Coating
All Models:
The protective coating covering the inside of the top
drawer must be removed before using.
Stainless Steel Models:
When inspecting/installing a Stainless Steel unit, the
protective coating covering the drawer fronts must be
removed. Start at a corner of the drawers and pull back
the protective coating to remove it from the drawer
fronts.
After all the protective coating has been removed from
the drawers, clean all Stainless Steel surfaces with Claire
Stainless Steel Polish and Cleaner or comparable product
or a mild detergent and warm water solution and soft
cloth. Do NOT use abrasive cleaning agents.
Note: If cleaning with mild detergent and warm water
solution and soft cloth, the unit MUST be treated with
Claire Stainless Steel Polish and Cleaner or comparable
product to prevent discoloration.
2 Inspect and Plan