Filter
Top Products
12 SS1095
MARINE SERIES
6. Install hinge on opposite side, bottom of cabinet
(Figure 18). Align hinge outer edge with cabinet
before tightening screws.
Figure 18
Figure 19
7. Relocate plastic spacer/bushing
(Figure 19)
on top and
bottom of door to opposite side. Clean out bushing
hole in door bottom with a screwdriver if necessary.
8. Using a Phillips screwdriver, remove the two screws
holding the custom stainless handle from the original
location, and remove the handle. Remove the two
screws on the opposite side of the door
(Figure 20)
. Do
not place handle on door until you have completed
steps 9 & 10
.
Figure 20
Figure 21
9. Remove plastic hole plug
(Figure 22)
from door handle
and relocate on opposite side. Lift the handle slightly
and press on the locking tab, then gently pry the hole
plug out of the hole being careful not scratch the top
cap.
Figure 22
10. Relocate plastic spacer/bushing on top of door that was
underneath the hinge to the opposite hole in top cap
11. Attach handle removed in step 7 to opposite side of
door frame. Be sure to tighten all four screws removed
in step 7.
12. Remove pivot screw from top hinge, invert screw and
reinstall pivot screw in top hinge
(Figure 21)
.
Plastic
Spacer/Bushing
ULIN_0109_A
ULIN_1049_A
Screw
ULIN_0142_A
Plastic
Plug Hole
Hinge
Plastic
Plug Hole
Right Side
Door Swing
Right
Side Hinge
Invert
Screw
Invert
Hinge
Left Side
Door Swing
ULIN_1050_A
Press in locking tab, then
lightly pry up to remove hole
plug and move to opposite
side