Filter
Top Products
SS1095 9
MARINE SERIES
1. Disconnect electrical power to the unit.
2. With a standard blade screwdriver or 1/4" nut driver,
remove the grille screw
(Figure 8)
.
3. Remove the grille.
WARNING
DO NOT touch the condenser fins. The condenser
fins are SHARP and can be easily damaged.
IMPORTANTIMPORTANT
DO NOT use any type of cleaner on the condenser
unit.
4. Clean the condenser coil using a soft brush with a
“combing” action or vacuum cleaner. Do not touch the
condenser coil.
5. Depending on your model, follow the instructions for
installing the grille
(Figure 9)
.
SS1095NF & SS1095FC models: Place the bottom lip of
the grille on the inside of the base pan and swing grille
up into position.
SS1095FD model: Align the tabs on the bottom of the
grille with the slots in the flange and swing grille up
into position.
Align the grille and cabinet screw holes
(Figure 9)
.
Figure 9
6. Insert the grille screw
(Figure 8)
and tighten. Do not
over-tighten.
7. Reconnect power to the unit.
Ice Maker Maintenance
Inlet Screen
Interval - Every Twelve Months
The solenoid valve inlet screen must be cleaned at least
once each year as follows:
WARNING
Disconnect electrical power to the unit before
cleaning the solenoid valve.
1. Disconnect electrical power to the unit.
2. Shut off the water at the main supply valve.
3. With a standard blade screwdriver or 1/4" nut driver,
remove the grille screw
(Figure 8)
.
4. Remove the grille.
WARNING
DO NOT touch the condenser fins. The condenser
fins are SHARP and can be easily damaged.
Figure 10
5. Disconnect the hose connector from the water solenoid
valve
(Figure 10)
.
6. DO NOT remove the inlet screen from the water
solenoid valve. Use a toothbrush to gently clean any
sediment from the inlet screen.
7. Re-connect the water supply hose connector to the
water solenoid valve
(Figure 10)
. Tighten the
connector securely.
8. Open the water main supply valve and check for leaks
at the water hose connection. Ensure that the water
supply line is not kinked.
9. Depending on your model, follow the instructions for
installing the grille
(Figure 9)
.
SS1095NF & SS1095FC models: Place the bottom lip of
the grille on the inside of the base pan and swing grille
up into position.
ULIN_1053_A
Insert this lip behind base plate lip
Align tabs
with slots
Models
SS1095NF
& SS1095FC
Model SS1095FD
Water
Solenoid
Valve
Hose Connector
ULIN_0064_A