U-Line SS1095 Ice Maker User Manual


 
8SS1095
MARINE SERIES
Proper cleaning and maintenance of your U-Line product
will ensure efficiency, top performance and long life. The
maintenance intervals listed are based on normal
conditions. You may want to shorten the intervals if you
have pets or other special considerations.
Interior Cleaning (As Required)
Turn unit off. Clean the interior and all removed
components using a mild non-abrasive detergent and
warm water solution applied with a soft sponge or
non-abrasive cloth. Rinse the interior using a soft
sponge and clean water.
Do not use any solvent-based or abrasive
cleaners. These types of cleaners may transmit
taste to the interior products and damage or
discolor the interior.
Defrosting
Manual Defrost Models - Every Two
Months (Minimum)
WARNING
DO NOT use any type of electrical heating device,
ice pick, knife or other sharp instrument to
defrost; this could damage the inner lining or
refrigeration system and void the warranty.
Figure 7
To defrost:
1. Turn unit off.
2. Remove ice bucket and discard ice.
3. Place a towel or other absorbent material on bottom of
unit.
4. If you would like, place warm water inside ice bucket.
Then place ice bucket back into unit and close door.
5. After approximately one hour, remove ice bucket and
discard water.
6. Allow the frost to completely melt naturally. Clean the
interior and ice bucket using a mild non-abrasive
detergent and warm water solution applied with a soft
sponge or non-abrasive cloth.
CAUTION
DO NOT use any solvent-based or abrasive cleaners.
They will discolor or damage the interior.
7. Dampen a soft sponge or non-abrasive cloth in clean
water and wipe down the cabinet interior and ice
bucket to remove any detergent residue. Rinse the
sponge or cloth in clean water and repeat as necessary
until the cabinet and ice bucket are clean.
IMPORTANTIMPORTANT
DO NOT place ice bucket in dishwasher. Dishwasher
will warp/discolor ice bucket and render it useless.
Condenser Cleaning
Interval - Every Three Months
To maintain operational efficiency, keep the front grille
free of dust and lint, and clean the condenser every three
months. Depending on environmental conditions, more
or less frequent cleaning may be necessary.
WARNING
Disconnect electric power to the unit before
cleaning the condenser.
To remove and replace the grille for access to the
condenser fins, follow this procedure:
Figure 8
6 Cleaning and Maintenance
ULIN_1045_A
Ice
Bucket
Model ULN-SS1095FD
Model ULN-SS1095NF/FC
ULIN_1045_A