Victory Refrigeration V-Series Refrigerator User Manual


 
Figure 2-8
Angle Type Pan Slides
The appropriate mounting uprights are already installed,
when ordered with your cabinet from the factory. Pan
slides cannot be attached to the standard shelf pilaster.
Pan slide uprights have 1/2” square holes on 1” centers.
To install an individual slide, locate the appropriate
square holes at the desired height. A complete section of
slides should be installed by starting at the bottom. Insert
tabs of the slide into the uprights and apply pressure in a
downward direction until the tab fully engages the upright
(refer to Figure 2-9).
Figure 2-9
Installing Stainless Steel Angle Type Pan Slides
b. Steel Rod Type Pan Slide Racks
(Refer to Figure 2-10)
Steel rod type pan slide racks are also available. They
are designed to accommodate 18” x 26” sheet pans as
follows:
Bottom Support Pan Slide Rack on 2” centers
Lip Support Pan Slide Rack on 1-1/2” centers
Uprights for mounting the steel rod type pan slide racks
are factory installed.
Figure 2-10
Steel Rod Type Slides
NOTE: Either pan rack can be used on any of one,
two or three section refrigerators.
I. Location of Serial Number/Data Plate
The serial data plate is mounted on the upper left interior
wall (see Figure 1-2).
J. Electric Supply
The wiring should be done by a qualified electrician in
accordance with local electrical codes. A
separate
ground wire must be supplied for all installations. A
properly wired refrigerator or freezer will assure proper
operation. Electrical supply requirements are on the
cabinet serial/data plate. It is recommended that a direct,
properly protected line of the proper size wire be
installed from the main supply to your refrigerator or
10
SECTION 2-INSTALLATION SECTION 2-INSTALLATION