Filter
Top Products
6 7
4. Within 10 seconds the SIX PRE-SET
buttons will be re-programmed and the
DISPLAY WINDOW will read ‘Saved’ then
‘Ready’. If nothing happens when the
programming chip is fully inserted, turn the
chip in the opposite direction and try again.
3. Remove the programming chip and return
it to the original package.
5. Press one of the six PRE-SET buttons to
reveal, in the DISPLAY WINDOW, the
name of the program/drink.
6. Carefully place the Blending Station motor
back into the hole in the counter.
NOTE: If for any reason the programmed
times are incorrect, they can be reset to
the original factory settings following the
instructions below.
Resetting the PRE-SET buttons to the original
factory settings
WARNING: Reverting your PRE-SET PROGRAM buttons to the
original factory setting, will erase any programming installed with a
custom program chip.
1. Enter the OWNER CONTROLS (press the Vita-Mix Logo) and press the
PRE-SET buttons 1 and 6 when the DISPLAY WINDOW says ‘Mode’.
2. Press the Vita-Mix Logo two more times to reveal the instructions on
resetting the PRE-SET buttons.
3. Press and hold the #4 button until the DISPLAY WINDOW reads
‘Restoring Please Wait’. The PRE-SET buttons are now reset to the
original factory settings.