Filter
Top Products
IN-COUNTER
HOLE
Cut
14 cm wide x
19 cm deep
19 cm
deep
14 cm wide
30.48 cm 30.48 cm
Additional Unit
(if applicable)
Additional Unit
(if applicable)
24.3 cm
44.45 cm
14.4 cm
15.2 cm
54.7 cm
31.75 cm
I
n-Counter Installation
8 9
Preparing the counter area:
• Before cutting holes, make sure that there is adequate clearance under
the counter for the motor. The motor will extend about 14.4 cm below the
counter but it is best to allow at least 25.4 cm from the under-counter to
shelves or any other equipment under the counter. Also, when using the
removable cover design, the back of the hole must be at least 15.2 cm
from any wall to allow for cover door clearance.
• An extra 16.5 cm of open space, above the top of the cover will be needed
for placement and removal of the In-Counter machine and for custom
programming the SIX PRE-SET Buttons.
• If installing unit into a closed cabinet, use a 10.1 cm diameter flexible vinyl
duct (dryer hose) to vent exhaust. Attach the vinyl duct to the bottom of
your In-Counter Touch and Go
TM
Blending Station
®
by forcing the end of
the hose over the exhaust baffle of the unit. Run the vinyl duct out of the
cabinet for proper ventilation. Do not vent hose into a wall, ceiling, or a
concealed space of a building. Multiple units should not vent to a common
manifold unit but to separate places. If running your Blending Station
causes a suction on your cabinet door, place a spacer in the door frame
to allow proper intake of air.
Do not use hose clamps or equivalent to attach exhaust hose
on machine.
• When cutting holes for placement of multiple In-Counter units, position
the edge of the machines at least 30.48 cm apart to ensure quick cleaning
and proper venting between machines.
• In-Counter installation also requires you to have at least one outlet per
machine under the counter, available within six feet of the Blending
Station. Consult an electrician for proper electrical needs.
• The In-Counter Blending Station also requires a foam gasket (provided
in the machine’s original package) to be placed between the machine
and the counter. See page 10 for instructions.
Electrical requirements:
• Volts: 220/240 VAC • 50 or 60 Hz. • 1073-1178 Watts
• Volts: 100 VAC, 60 Hz., 900 Watts (Japan)
Blending Station dimensions:
• 44.45 cm high with lid closed
• 54.7 cm high with lid open
• Case depth: 31.75 cm with handle
• Case width: 24.3 cm
• Depth below counter: 14.4 cm
• Recommended distance between machines: 30.48 cm from the edge of
each machine or as far apart as possible.