Filter
Top Products
17
Dimensions:
Height of Motor Base: 8-1/2” (21.25 cm)
• with 64 oz (2 liter) Polycarbonate container and lid: 20” (50 cm)
• with 64 oz (2 liter) Polycarbonate container without lid: 18” (45 cm)
• with 48 oz (1.4 liter) Polycarbonate container and lid: 17-1/2” (46.75 cm)
• with 48 oz (1.4 liter) Polycarbonate container without lid: 9-1/4” (44.75 cm)
64 oz (2 liter) Polycarbonate Container with lid, no base: 12-3/4” (32 cm)
48 oz (1.4 liter) Polycarbonate Container with lid, no base: 10” (25.5 cm)
Dimensions: 8” W x 9” D x 20” H (20.3 cm x 22.9 cm x 51 cm)
Ship weight of machine: 13 lbs. (6 kg)
Power Requirements:
Volts: 120 VAC
Amps: 11.5
Hz: 50/60
The instructions appearing in this Owner’s Manual cannot cover every possible
condition and situation that may occur. Common sense and caution must be
practiced when operating and maintaining any appliance.
16
1. Problem:
• increased vibration
• leaking from bottom of container
• increased container noise
Solution #1:
Check blade assembly for loose, damaged
or nicked components and replace.
Solution #2:
Tighten retainer nut with screwdriver
moving clockwise until it is snug. See p. 10.
3. Problem:
• loud noise from blade area
• blades don’t spin
Solution:
Drive Socket may be broken. Check for a
fine crack down the center or worn teeth-
replace with a new drive socket. (Item #
802). Instructions are included with part.
4. Problem:
• Bar Boss/Timer Blender will not run
when START TIMER switch is
activated.
Solution:
Check ON/OFF switch to make sure the
switch is in the ON position. Note: START
TIMER switch is lit when power is on.
2. Problem:
• Machine will not run.
Solution #1:
Double-check to make sure power cord is
firmly in power outlet.
Solution #2:
Check to make sure switches are clean
and moving freely.
Solution #3:
The thermal protector may have turned the
machine off. Turn power off for up to 30
minutes to reset. Note: Cooling may be
quickened by placing the motor base in a
refrigerator or cool spot. (Unplug first). To
speed up the cooling process, try circulat-
ing the air with a fan or vacuum at the bot-
tom of the motor base.
Top four problems you can fix on your own
On Two-Step Timers:
Timer stops working if machine is overloaded on low speed. Reset by turning power
off for 15 seconds. Do not turn power off midway through a blending cycle. To interrupt
cycle, press START/STOP TIMER switch one time. See page 9.
If you cannot fix your machine with these suggestions, technical help is available by
calling 800-4DRINK4 (800-437-4654). If you live outside the USA, contact your local
Vita-Mix distributor.
Volts: 220/240 VAC
Watts: 750-850
Hz: 50/60
Volts: 100 VAC
Watts: 900
Hz: 50/60