Filter
Top Products
TROUBLESHOOTING
16
1. Problem:
• Increased vibration
• Leaking from bottom of container
• Increased container noise
Solution #1:
Check blade assembly for loose, damaged or
nicked components and replace.
Solution #2:
Tighten retainer nut with retainer nut wrench
moving clockwise until it is snug. See page 10.
3. Problem:
• Loud noise from blade area
• Blades don’t spin
Solution #1:
Drive socket may be broken. Check for a
fine crack down the center or worn teeth -
replace with a new drive socket (Item
#891). Instructions are included with part.
Solution #2:
Blade bearings need to be replaced. Spin
the blades using the drive spindle at the
bottom of the container.If blades spin freely
with no resistance, replace blade assembly.
See page 10.
Solution #3:
Drive spindle on the blade assembly may be
worn. Check for worn teeth on the drive
spindle of the blade assembly. Replace
blade assembly. See page 10.
2. Problem:
• Machine will not run
Solution #1:
Double-check to make sure power cord is
firmly in power outlet.
Solution #2:
Check to make sure the ON/OFF Switch is in
the ON position. Check to make sure
switches are clean and moving freely.
Solution #3:
The thermal protector may have shut the
machine off. Turn power off for up to 45
minutes to reset.
Note:
Cooling may be
quickened by placing the motor base in a
cool spot. (Unplug first.) Try circulating the air
with a vacuum or fan aimed at the bottom of
the motor base.