Filter
Top Products
– 6 –
SERVICE & PARTS H SERIES
LIGHTING AND SHUTTING DOWN PILOT BURNERS (Cont.)
STANDARD OVEN PILOT
NOTE: Before lighting oven, be sure that range top
sections have been lit.
1. Open oven door and lift up the pilot lighting hole cover.
2. Light oven pilot by depressing red reset button (Fig. 1)
located on the side control panel above the thermo-
stat knob. Light the pilot and continue to hold the reset
button in for one minute.
Fig.1
3. If pilot fails to light, turn main gas supply OFF and wait
5 minutes before repeating Steps 1 and 2.
4. After pilot is lit, close lighting hole cover and oven
door.
5. Set oven thermostat to desired temperature.
Nightly Shutdown
Turn oven burner valve OFF.
Complete Shutdown
1. Turn burner valve OFF.
2. Turn main gas supply OFF.
CONVECTION OVEN PILOT
NOTE: Before lighting oven, be sure that range top
sections have been lit.
1. Connect unit to the main electrical supply line. Open
oven door panel and lift up the pilot lighting hole
cover.
2. Turn red gas valve (located behind the control panel)
ON, purging the gas line of all air. Turn gas valve and
power switch OFF. Close oven door.
3. Light oven pilot by depressing the red pilot reset
button (see Fig. 1), and using a taper, ignite the pilot.
Hold reset button in for 30 seconds, or until pilot
remains lit. Turn gas valve back ON.
4. If pilot fails to light, turn main gas supply OFF. Wait
5 minutes and repeat Steps 2 and 3.
5. After pilot is lit, push the power switch ON and turn
the temperature dial to the desired setting.
Nightly Shutdown
Turn power switch OFF and the temperature dial to
0 degrees.
Complete Shutdown
1. Push power switch OFF.
2. Turn red gas valve (located behind the control panel)
OFF.
3. Turn main gas supply OFF.
4. Disconnect electrical supply cord.