C24EO SERIES STEAMERS - REMOVAL AND REPLACEMENT OF PARTS
Handle Installation
1. Apply Lubriplate 630AA around slots of outer
door housing where step spacers contact
housing.
2. Install door handle into outer door housing such
that hinge side of door housing is to the left and
arrow on handle is pointed upward.
3. Install step spacer with smaller radius toward
handle and door housing. Smaller radius is a slip
fit with outer door housing slot.
4. Install lock nuts and tighten until no gap exists
between handle, step spacer and lock nut. Do
not over-tighten lock nuts.
5. Close inner door panel so that latch mechanism
engages striker on front panel.
6. Install outer door housing onto inner door panel.
7. Align the top and bottom screw holes of outer
door housing with inner door panel.
8. Apply Loctite 7471 Primer N and Loctite 242 to
threads of screws before assembling.
9. Install screws to secure door halves together.
10. Check opening and closing operation of door.
Latch Assembly Removal and Disassembly
1. Separate outer door housing assembly from
inner door panel as outlined under DOOR
HANDLE REMOVAL.
2. Remove screws securing latch assembly to inner
door panel and remove latch mechanism.
3. Remove E-clip from latch assembly pins and pull
pins from latch mechanism.
4. Remove retaining pin from spring pin.
5. Separate sliding bracket from stationary bracket.
F25386 (June 2010)Page 11 of 24