Filter
Top Products
C24EO SERIES STEAMERS - REMOVAL AND REPLACEMENT OF PARTS
C. Install thermostat hand tight. Do not over
tighten.
TEMPERATURE PROBE
1. Remove right SIDE PANEL and REAR PANEL.
2. Disconnect probe leads from the temperature
control.
3. Remove temperature probe from steam vent
pipe.
4. Reverse procedure to install replacement probe
and check steamer for proper operation.
5. Adjust temperature control as outlined under
TEMPERATURE CONTROL CALIBRATION in
SERVICE PROCEDURES AND
ADJUSTMENTS.
HEATING ELEMENT ASSEMBLY
Removal
The heating element assembly contains elements
molded into a cast aluminum block. The block is
mounted on the underside of cooking compartment.
Heating element assembly sits on springs which
compress to hold assembly tight to bottom surface of
steam chamber but allow for thermal expansion and
contraction.
1. Remove right SIDE PANEL.
2. Remove screw and heat shield.
3. Remove bolts.
NOTE: Support heating element assembly while
removing last bolt.
4. Disconnect heating element leads from 1CON
and 2CON, noting their locations.
F25386 (June 2010) Page 8 of 24