Vulcan-Hart G260 Range User Manual


 
— 11 —
OPERATION
WARNING: THE APPLIANCE AND ITS PARTS ARE HOT. USE CARE WHEN OPERATING,
CLEANING OR SERVICING THE APPLIANCE.
CONTROLS
Range Top Burner Valve Allows gas to flow to the top burners. To open valve, turn knob
counterclockwise. To close valve, turn knob clockwise.
Yellow Gas Shut-off Valve Allows gas to flow to the range top. To open valve, turn knob
counterclockwise. To close valve, turn knob clockwise.
Thermostat / Safety Valve Regulates the oven temperature and pilot safety thermostat.
The thermostat temperature range is from LOW at
approximately 300°F (149°C) to HI at approximately 550°F
(288°C). Turn thermostat clockwise to increase temperature
and counterclockwise to decrease temperature.
NOTE: In P position, pilot remains on. In OFF position, pilot
is extinguished. During shut down and operation, align the
OFF and P positions (as required) of the oven knob with the
tick mark (* or V) indicator on the label or sheet metal located
above the knob. This indicator should also be used as the
temperature set mark.
Fan Switch Turns fan on and off.
(Convection Ovens Only - Fan turns ON when door is closed.
Fan turns OFF when door is opened)
BEFORE FIRST USE
Griddles
Griddle tops are shipped with a protective coating of grease. Remove this film only when the griddle
plate is being cleaned prior to its first cooking use. Use a non-corrosive, grease dissolving
commercial cleaner, following manufacturer's directions. Rinse thoroughly and wipe dry with a soft
clean cloth. Clean all accessories. Rinse thoroughly and wipe dry.
Caution: This griddle plate is steel, but the surface is soft and can be scored or dented
by careless use of spatulas or scrappers. Be careful not to dent , scratch or gouge the
plate. Do not try to knock off loose food that may be on the spatula by tapping the
corner edge of the spatula on the griddle surface.
A new griddle surface must be seasoned to do a good cooking job. The metal surface of the griddle
is porous. Food tends to get trapped in these pores and stick. It is important to season the griddle
with cooking oil before using the griddle. Seasoning will give the griddle surface a slick, hard finish
from which food will easily release.
Season the griddle top plate at low setting. Pour one ounce of cooking oil onto the plate per square
foot of the griddle surface. With an insulated cloth, spread the oil over the entire griddle surface.
Wipe off any excess oil. Repeat this procedure 2 to 3 times until the griddle has a slick looking
surface.