Filter
Top Products
Bottom
HEATING CONTACTORS
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
1. Remove
CONTROL BOX COVER.
2. Note location of lead wires then disconnect the
wires from contactor being replaced.
3. Remove screws securing the contactor to panel.
4. Reverse procedure to install and check for proper
operation.
Fig. 7
TEMPERATURE CONTROLLER
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
1. Remove CONTROL BOX COVER.
2. Disconnect lead wires from temperature
controller.
3. Remove screws securing the temperature
controller to panel.
4. Reverse procedure to install and check for proper
operation.
Fig. 8
WATER LEVEL CONTROL
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
1. Remove CONTROL BOX COVER.
2. Disconnect lead wires from the water level
control.
3. Remove screws securing the water level control
to panel.
4. Reverse procedure to install and check for proper
operation.
Electric Stationary and Tilting Kettles - REMOVAL AND REPLACEMENT OF PARTS
F45472 (1112) Page 6 of 29