Filter
Top Products
Fig. 9
MAIN TRANSFORMER
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
1. Remove
CONTROL BOX COVER.
2. Disconnect lead wires from the transformer.
3. Remove screws securing the transformer to
panel.
4. Reverse procedure to install and check for proper
operation.
Fig. 10
HEATING ELEMENT
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
TILTING KETTLE
1. Open pressure relief valve until reservoir jacket
is completely vented.
2. Remove
BOTTOM COVER.
3. Remove wire from water level probe (LLCO).
4. Place a large container under the kettle. Remove
water level probe (LLCO) and open the fill valve
(40 & 60 gallon kettles) or remove pipe plug from
fill elbow (20 gallon kettles) to vent the jacket and
drain liquid from kettle.
Electric Stationary and Tilting Kettles - REMOVAL AND REPLACEMENT OF PARTS
Page 7 of 29 F45472 (1112)