Filter
Top Products
2-28
REMOVING THE HIGH VOLTAGE RECTIFIER
AND THE HIGH VOLTAGE CAPACITOR
WARNING
Personal Injury Hazard
Disconnect from the electrical supply be-
fore servicing the unit. Failure to do so
could result in death or electrical shock.
1. Disconnect the electrical supply to the
microwave oven.
WARNING
Personal Injury Hazard
Disconnect from power supply before ser-
vicing. Discharge the capacitor using a
20,000-ohm discharge resistor, or an insu-
lated plastic-handle screwdriver to short
across the capacitor terminals.
2. Discharge the high-voltage capacitor.
3. Remove the two screws from the top of
the cabinet for the vent grille and remove
the grille (see the illustration on page
2-3).
4. Remove the control panel from the micro-
wave oven (see page 2-6).
5. From inside the control panel opening,
remove the screw from the capacitor
bracket, and remove the bracket and ca-
pacitor so that you can access the capaci-
tor terminals.
6. Unplug the wire connectors and the high
voltage rectifier from the capacitor termi-
nals and remove the capacitor and recti-
fier from the oven.
7. Install the high voltage rectifier and ca-
pacitor and reassemble the microwave
oven.
ORG TO
MAGNETRON
RED TO HV
TRANSFORMER
HV RECTIFIER
HV RECTIFIER
MOUNTING
SCREW
STRAP