Filter
Top Products
Cleaning the condenser
Personal Injury and
Product Damage Hazard
l
Be sure the ice maker is OFF and
disconnected from the main power
supply. Unit could suddenly start if not
disconnected. Condenser fan rotation,
sharp condenser fins, and hot tubing
could cause personal injury.
l
Condenser fins can bend easily. Use
care when vacuuming the condenser
to keep from bending the fins.
Failure to follow the above precautions
could result in personal injury or product
damage.
1.
Disconnect electrical power supply to the
ice maker and turn the Cycle Control Knob
to “OFF.”
2. Remove the two screws in the lower grille
area and the one screw from the center of
the front panel support. (Open bin door
slightly for better access to screw.)
3. Pull forward and down to remove the lower
access panel.
4. Remove dirt and lint from the condenser
fins and the unit compartment with a brush
attachment attached to a vacuum cleaner.
5. Replace the lower access panel and
screws. The top of the access panel needs
to be secured under the two metal tabs
before replacing the screws.
6. Reconnect unit to electrical power supply,
and turn the Cycle Control Knob to “ON.”
10