Filter
Top Products
Setting the controls
1. Select ice thickness. The ice maker has
been preset to produce ice approximately
l/z” (13 mm) thick, while operating in a
room temperature of 70°F (21°C).
Operation in different room tempera-
tures may require readjusting the control
toward “THICK” or “THIN.”
Best operation will be obtained with ice
l/z’ (13 mm) to %I’ (16 mm) thick.
If operating in a warm room (above
90°F [32X]) DO NOT set control to
maximum thickness or the unit may
malfunction.
2. To start the normal ice making cycle, turn
the Cycle Control Knob to “ON.”
3. To stop ice maker operation, turn Cycle
Control Knob to “OFF.”
The “CLEAN” setting is used whenever
solutions are circulated through the ice
maker for cleaning. Only the water pump
operates at this setting. See “Cleaning the
ice maker system” on page 11 for specifii
instructions.
Changing the bin door panel
You can easily change the color of the front
panel on the storage bin door. Two colors
are available: Black and White.
To change panel:
1. Open the storage bin door. Remove the
two screws on the top of the door, which
hold the handle.
2. Loosen the screws in both of the side trim
pieces.
3. Remove the handle and the handle insert.
4. Carefully slide the panel out. You will find
the reverse side is white. For units with
white panels showing, the reverse side
will be black.
5. Choose the color you want to show and
carefully slide the panel back into the
door.
NOTE: Be careful not to scratch the panel
as it is inserted.
6