Filter
Top Products
6. Replace the handle insert and tighten the
screws in both side trim pieces. Replace
the handle and the screws.
NOTE: You
can make a decorative wood
front to match existing cabinets. The panel
should be l/r* (6 mm) thick and 17” x llV4”
(4% mm x 266 mm). Remove the color
panel and break off the ribs on the door
insulation to allow for wood thickness.
Changing the lower access panel
Electrical Shock Hazard
Do not operate ice maker with lower
access panel or control panel removed.
Electrical shock or personal injury could
result.
1. Remove the two screws in the lower grille
area and the one screw from the center of
the front panel support. (Open bin door
slightly for better access to screw.) Pull
forward and down to remove the lower
access panel.
2. Remove the two screws from the top panel
trim and remove the top trim.
3. Carefully slide the panel out.
4. Choose the color you want to show and
carefully slide the panel back into the lower
access panel.
NOTE:
Be careful not to scratch the panel
as it is inserted.
5. Replace the top trim and screws. Replace
the lower access panel assembly and
screws.
NOTE:
You can make a decorative wood
front to match existing cabinets. The panel
should be l/4* (6 mm) thick and 17” x 1 115/16”
(433 mm x 303 mm). Remove the color
panel and spacers to allow for wood
thickness.