Filter
Top Products
The beeping sound
Each time a control pad is pressed, a single
“beep” sound is made. A double beep means one
of the extra features was selected (such as control
pad lock-out) or the wrong control pad was used.
To turn off the beep:
1. Press and hold the OPTIONS pad until the
CLEAN signal light flashes.
2. Release the pad. The CLEAN signal light will
turn off.
NOTE: A power failure will reset this feature.
You will have to repeat the above steps.
To turn the beep back on:
1. Press and hold the OPTIONS pad until the
CLEAN signal light turns on and stays on.
2. Release the pad. The CLEAN signal light will
turn off.
The WATER HEATING signal light
The WATER HEATING signal light comes on during
the water heating portion of the Pots & Pans Cycle.
The signal light will also come on during the water
heating portion of other cycles when the Hi-Temp
Option is selected.
The WATER HEATING signal light will flash
at the end of the cycle if the water did not heat to
140°F (60%). If you want to make sure the water
gets heated to 140°F (SO%), use the Hi-Temp
Option (see page 11).
When the signal light is on, water is being heated.
The heating time is based on the temperature of
the water supply as it enters the dishwasher. The
cooler the water, the longer the heating time. The
WATER HEATING signal light will go off when the
water temperature reaches 140°F (SO’C).