Filter
Top Products
Operating Instructions
Continued
The CLEAN signal light
The CLEAN signal light comes on at the end of a
cycle to show that the load is clean. It will stay on
until CANCEL/DRAIN or any other control pad is
pressed.
As an option, you can have the CLEAN light turn
off the first time you open the door after a cycle
is finished:
1. Press and hold the CYCLE pad until the
CLEAN signal light starts flashing.
2. Release the pad. The CLEAN signal light will
turn off.
NOTE: A power failure will reset this feature.
You will have to repeat the above steps.
To again have the signal light stay on when the
door is opened:
1. Press and hold the CYCLE pad until the CLEAN
signal light turns on.
2. Release the pad. The CLEAN signal light will
turn off.
Flashing signal lights
The signal lights will flash rapidly in order when
your dishwasher is first installed and connected to
electricity. The signal lights will also flash following
a power failure. Press the CANCEL/DRAIN pad
twice to clear the signal lights