Filter
Top Products
11
GETTING TO KNOW YOUR MICROWAVE OVEN
NOTES:
• If you choose an automatic cooking func-
tion and change your mind, you must
press OFF/CANCEL before you choose
another automatic cooking function.
• If you attempt to enter unacceptable
instructions, three tones will sound, and
“Err” will appear on the display. Touch
OFF/CANCEL and re-enter the instructions.
• Once you choose a function, an indica-
tor light (▲) will flash as a prompt for the
next action you need to perform.
• If you choose a function but do not press
another command pad within one minute,
the display returns to the time of day and
you have to start over.
• If you have entered all settings for a
function but do not touch START/ENTER
in 5 seconds, the Start? indicator light will
flash.
• If you open the door while the oven is on
and then shut the door, the Start? indicator
light will flash.
Audible signals
Audible signals are available to guide you
when setting and using your oven:
• A programming tone will sound each
time you touch a pad.
• Five tones signal the end of a cooking
cycle and two tones will sound every
minute until you open the door or press
OFF/CANCEL.
• Three tones will sound if you enter
incorrect instructions.
Interrupting cooking
You can stop the oven during a cycle by
opening the door. The oven stops heating
and the fan stops, but the light stays on.
To restart cooking, close the door and
If you do not want to continue cooking:
• Close the door and the light goes off.
OR
• TOUCH
NOTE: Before setting a function, touch
OFF/CANCEL to make sure no other
function is on.
TOUCH
13. Number Pads. Touch Number pads to
enter cooking times, cook powers,
selection quantities or weight.
14. MINUTE TIMER. Touch this pad
followed by number pads to use as a
kitchen timer.
15. START/ENTER. Touch this pad to start a
function that you have set.
16. ADD MINUTE. Touch this pad to cook for
one minute at 100% cook power or to add
an extra minute to your cooking cycle at
current power.
17. OFF/CANCEL. Touch this pad to erase
an incorrect command, to cancel a
program during cooking, or to clear the
display after a function is completed. This
pad will not erase time of day.
4393788v06(c98).qx 5/6/98 1:58 PM Page 11