Filter
Top Products
Using CANCEL DRAIN
CANCEL
Push the CANCEL
DRAIN
DRAIN Button to stop
F
any cycle at any time
for any reason.
l
All dishwasher ac-
tion will stop and
water will drain from
the dishwasher.
l
The draining will take about 2 minutes. The
RINSE/DRY Signal Light will be on during this
time.
l
When the dishwasher is drained, all signal
lights will go off.
l
Select a new cycle, if desired.
NOTE: When CANCEL DRAIN is pushed, the timer
automatically moves to a drain position. You
may hear the timer ticking or clicking as it
advances. This is a normal sound.
If CANCEL DRAIN is pushed near the end of a
cycle, the CLEAN Signal Light may come on. To
turn it off. Push CANCEL DRAIN again.
The signal lights
WATER
HEATING
RINSE/
DELAY
HOLD
WASH DRY CLEAN
m m m m m
Signal lights go on and off during a cycle to
Control-is used. Stays on until selected cycle
let you know what your dishwasher is doing.
DELAY Light-Comes on when DELAY WASH
starts.
WATER HEATING HOLD Light - Comes on when
the dishwasher is heating water (to 145”F/63”C)
It will siay on until CANCEL DRAtN Button is
during the wash or rinse portion of the cycle.
WASH Light-Comes on when washing action
pushed.
starts. Stays on until water from the last wash
is drained away.
RINSE/DRY Light-Comes on during final rin-
ses. Stays on during the “dry” part of the
cycle. It goes off after the last rinse if the AIR
DRY Option is used.
CLEAN Light - Comes on when a cycle is over.
To add a dish after starting
1. To be sure the added item is washed,
make sure the WASH Signal Light is still
on and that the covered section of the
detergent dispenser has not opened.
2. Unlatch the door to stop the cycle, but
don’t open it until the spray arms stop
spinning.
3. Open the door and add the dish
4. Close the door. Do not latch It. Wait 30
seconds for air in the dishwasher to warm
up. This helps reduce the amount of
moisture that can come from the vent
when restarting the cycle.
5. Latch the door. The dishwasher will restart
and continue the cycle.