Whirlpool 9758899 Range User Manual


 
25
Storage Drawer
The storage drawer can be removed. Before removing, make sure
drawer is cool and empty.
To remove:
1. Pull drawer straight out to the first stop.
2. Lift up the back of the drawer and pull out.
To replace:
1. Fit the ends of the drawer rails into the guides in the cavity.
2. Slide the drawer closed.
Warming Drawer
(on some models)
Remove all items from inside the warming drawer, and allow the
unit to cool completely before attempting to remove the drawer.
To Remove:
1. Open drawer to its full open position.
2. Locate the black triangle-shaped tabs on both sides of the
drawer.
A. Tab
3. Press the tab down on the right side, and lift tab up on the left
side at the same time, then pull drawer out another inch.
4. Holding the drawer by its sides, not its front, carefully pull it
all the way out.
To Replace:
1. Align the drawer glides with the receiving guides.
2. Push drawer in all the way.
3. Gently open and close the drawer to ensure it is seated
properly on the slides.
TROUBLESHOOTING
Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.
Nothing will operate
Is the power supply cord unplugged? Plug into a grounded
outlet.
Has a household fuse blown, or has a circuit breaker
tripped? Replace the fuse or reset the circuit.
Cooktop will not operate
Is the control knob set correctly? Push in knob before
turning to a setting.
Excessive heat around cookware on cooktop
Is the cookware the proper size? Use cookware about the
same size as the surface cooking area, element or surface
burner. Cookware should not extend more than 1" (2.5 cm)
outside the cooking area.
Hot Surface indicator light stays on
Does the Hot Surface indicator light stay on after control
knob(s) have been turned off? See Cooktop Controls
section.
Cooktop cooking results not what expected
Is the proper cookware being used? See Cookware
section.
Is the control knob set to the proper heat level? See
Cooktop Controls section.
Is the appliance level? Level the appliance. See the
Installation Instructions.
Oven will not operate
Is the electronic oven control set correctly? See
Electronic Oven Control section.
Has a delay start been set? See Timed Cooking section.
On some models, is the Control Lock set? See Control
Lock section.
Oven temperature too high or too low
Does the oven temperature calibration need adjustment?
See Oven Temperature Control section.
Oven indicator lights flash
Do the oven indicator lights flash? If the indicator light(s)
keeps flashing, call for service. See Assistance or Service
section.
A