Whirlpool EV150NXK Freezer User Manual


 
Before you plug it in
Before using your freezer, you are personally
responsible for making sure that it...
l
is installed and leveled on a floor that will
hold the weight, and in an area suitable for
its size and use.
l
is connected only to the right kind of outlet,
with the right electrical supply and
grounding.
0 is used only for jobs expected of home
freezers.
l
is not near an oven, radiator or other heat
source
l
is prc:perly maintained.
l
is in C.I dry sheltered place.
l
is used in an area where the room tempera-
ture will not exceed 110°F (43.3C).
l
is not run where there are explosive fumes.
l
is not ,Jsed by children or others who may
not
understand how it should be used.
l
is not loaded with food before it has time to
get properly cold.
Install Properly...
Remove Sales labels...
Flush against back wall
llll
1. Check the strength of the floor. It should hold
the weight of fully loaded freezer.
2. Pick a safe place, indoors, away from in-
flammables such as gasoline.
3. Freezer may be installed flush against wall
in back.Allow % inch (1.25 cm) on each side
of cabinet.
level Freezer.. .
so that door will stay open at any position.
1. Remove base grille (see page 4 1. T
1
2. Starting with door hinge sid
turn left to raise corner.
3. Turn right to lower corner.
4. Check with level.
5. After freezer is loaded with
food, recheck with level.
2
Raise
Lower
Rem:>ve the Consumer Buy Guide label and
any inriide labels before using the freezer. Re-
move c:lny left over glue with rubbing alcohol.
I
Note: DC NOT REMOVE the Tech Sheet fas-
tened behind the base grille.
I
Cleain It...
Clec:n your freezer before using it. See clean-
ing instructions on page 5,
Plug it in...
3-prong grounding
type wall receotacle II I
Freezer
power cord
grounding plug
Recommended Grounding Method
AlZLI
Volt, 60 Hz., AC only,15 or 20 ampere fused
electrical supply is required. It is recommended
that a :,eparate circuit serving only this appliance
be provided. The receptacle should not be con-
trolled by a wall switch or pull chain.
Do not use an extension cord.
See Individual electrical requirements and
grounding instruction sheet in your literature
package.