Filter
Top Products
.
Using your freezer
Setting the Cold Control...
To start, turn control to the middle of the dial.
This setting will maintain zero zone temperatures
under normal operating conditions.
Adjusting Cold Control . . .
l
Turn control to higher number for colder
temperatures.
l
Turn to lower number for less cold temperatures.
Cooling Freezer First.. .
l
Allow freezer to cool 6 to B hours before filling
with frozen food.
l
Let it cool overnight before adding large
amount of unfrozen food.
Note: When freezer is first started the compressor
will run constantly until the cabinet is cooled. It
may take up to 6 to 8 hours or longer, depending
on room temperature and the number of times
the freezer door is opened.
After the cabinet is cooled the compressor will
turn on and off as needed to keep freezer at
proper temperature.
*
POWER SAVING CONTROL
SAVES
POWER
OFF
ON
The Power Saving Control
n
. .
operates electric heaters. These heaters help
prevent moisture from forming on the outside of
the freezerwhen humidity is high.
l
Use the OFF setting when humidity is low to save
electricity.
l
Use ON only if moisture forms on outside of
freezer.
Exterior Signal light...
automatically warns of any unexpected power
failure.
If the signal light is not glowing, immediately
check:
0 for power interruption,
l
the power cord; it may be disconnected from
the outlet,
l
the signal light; it may be burned out.
To replace burned out signal light:
1. Unp ug power cord from outlet.
2. Rem’:.)ve base grille. See page 4
3. UnpllJg burned out light and replace with one
of sc me wattage and size. Signal light can be
ordered from your WHIRLPOOL dealer, Part No.
5305184.
4. Replace base grille. See page 4.
5. Plug power cord into outlet.
3