Filter
Top Products
Changing the light bulb...
Light Shield
WARNING: To avoid possible shocks, first unplug
I
freezer or turn off electricity leadlng
to freezer at the main power supply.
:I
1 Remove the light shield from the side of the control
panel. Depress the bock of the shield to release the
I
II
tabs, then pull away.
2. Replace bulb with a 40.watt appliance bulb.
3. Replace the light shield. Insert the shield tabs in the
slots, then press the shield to snap into place
4. Plug in power cord or switch on electricity.
Removing the bottom basket...
To remove:
1 Lift front of basket out of supports.
2. Pull out
Lift the Front,
Then Pull Out
To replace:
1 PosItton bock of basket on the rear wall supports
2 Lower front Into place.
I
The key eject lock...
con heir, reduce the hazard of child
entrapment
The signal light...
automatically warns of any unexpected
power failure.
--
Signal Light
/
If the signal light is not glowing, immediately check.
l
for power interruption,
l
for on unplugged power cord,
l
for a burned out signal light
To lock or unlock the freezer you must hold the
key in the lock while turning The lock IS spring
loaded so the key cannot be left in the lock.
If the key IS lost, contact your WHIRLPOOL
dealer for a replacement. Always give the com-
plete model and serial number of your freezer
when requesting a replacement key.
To replace burned out signal light:
1, Unplug power cord from outlet
2 Open the freezer door.
3. Unplug burned out light and replace with one of
same wattage and size. Signal light con be
ordered from your WHIRLPOOL dealer,
Part No. 1103680
4. Close freezer door and plug power cord into outlet.