Filter
Top Products
Lighting standing pilots
(mode& FGP21OV, FGP3WB and FGPNOB)
To light range pilots:
1. Make wre all controls are tumed off.
2. Remove
the surface burner grates
from
the cookhp. Remove the cookop. (See
“Removing the woklop” on page 18.)
3. To light, hold a lit match over the pilot
light located between the front and back
burners. The pilot flame should be %fo
% in (.6-l cm) high.
4. If the pilot flame needs adJustment,
turn the pilot adjustment screw behind
the Oven Temperature Control, under the
control panel.
5. Replace the cooktop and the
grates
before using the surface burners.
To light oven burner pilot:
1. Make sure the Oven Temperature
CoMrol k turned off.
2. Pull broiler drawer open. Broiler door will
till down when opened.
3. Remove broiler pen, grid, and broiler
carriage. (SW “Removing the broiler
carriage” an page 21.)
4. Hold a lit match over the oven burner
pilot located at the rear of the burner.
5. After the oven burner pilot is burning
steadily, check burner lighting by turning
the Oven Temperature Control to a
tempemture above 140°F (60%). The
burner will take 50-W Seconds to light.
6. Replace the burner carriage, broiler pan,
and grid.
Pllot
ad Jumtment
8CCreW
! ‘1
4
7. Close broiler drawer all the way.
11