Filter
Top Products
7
Displays
When power is first supplied to the appliance, everything on both
displays will light up for 5 seconds. Then, “PF id = 27” or “PF id =
30” will appear on the lower oven display. Touch OFF/CANCEL to
clear display.
Any other time “PF id = 27” or “PF id = 30” appears, a power
failure occurred. Touch OFF/CANCEL and reset the clock if
needed.
Lower Oven Display
When the lower oven is in use, this display shows the lower oven
temperature, heat source(s) and start time.
During lower oven Timed Cooking, this display also shows a
vertical bar and minute time countdown and the stop time (if
entered).
If “Err” appears on the display, an invalid pad was touched.
Touch OFF/CANCEL and retry your entry.
When the lower oven is not in use, this display is blank.
Upper Oven Display
When the upper oven is in use, this display shows the upper oven
heat source(s), cooking power, quantities, weights and/or help
prompts.
If “RETRY” flashes on the display for one second, an invalid pad
was touched. Retry your entry.
When the upper oven is not in use, this display shows the time of
day or Timer countdown.
Add Minute, Start
Starting
The ADD MINUTE START pad begins any upper oven function
except the Timer. If not touched within 5 seconds after touching a
pad, “START?” will appear on the upper oven display as a
reminder. If not touched within 5 minutes after touching a pad,
the oven display will return to the time of day mode and the
programmed function will be canceled. If cooking is interrupted,
touching ADD MINUTE START will resume the preset cycle.
Adding Minutes
During High Speed Cooking, Crisping and Broiling, touching ADD
MINUTE START while the oven is operating will add cook time in
one minute increments.
During Microwave Cooking, touching ADD MINUTE START while
the oven is operating, or at the end of a cycle, will add cook time
at 100% cook power in one minute increments.
During Convection Cooking, touching ADD MINUTE START will
not add minutes.
Off/Cancel
The upper oven OFF/CANCEL pad stops any upper oven
function except for the Clock, Timer and Control Lock.
The oven will also turn off when the door is opened. When the
door is opened, the element(s) and fan will turn off, but the upper
oven light will remain on. Close the door and touch ADD MINUTE
START to resume the cycle.
Clock
This is a 12-hour clock and does not show a.m. or p.m.
To Set:
Before setting, make sure the ovens, Timer and Timed Cooking
are off.
1. Touch CLOCK.
2. Touch the number pads to set the time of day.
3. Touch CLOCK, START/ENTER or ADD MINUTE START.
To remove the time of day from the display: Touch and hold
CLOCK for 5 seconds.
To return the time of day to the display: Touch CLOCK. The
time should not have to be reset.
Tones
Tones are audible signals, indicating the following:
One tone
■ Valid pad touch
■ Oven is preheated
■ Function has been entered
Three tones
■ Invalid pad touch
Four tones
■ End-of-cycle
■ Reminder, repeating each minute after the end-of-cycle tones
All Tones
All of the above tones are preset on, but can be turned off.
To Turn Off/On: Touch and hold STOP TIME for 5 seconds. A
tone will sound and “Snd oFF” will appear on the lower oven
display for 3 seconds. Repeat to change back to “Snd on.”
Tone Volume
The volume is preset at high, but can be changed to low.
To Change: Touch and hold the number pad “7” for 5 seconds. A
tone will sound and “Snd Lo” will appear on the lower oven
display for 3 seconds. Repeat to change back to “Snd HI.”
REMINDER TONES
The Timer and Timed Cooking reminder tones are preset on, but
can be turned off. Reminder tones do not include end-of-cycle
tones. If “All Tones” have been turned off, the reminder tones
cannot be independently turned on.
Timer
To Turn Tones Off/On: Touch and hold TIMER SET until a tone
sounds. Repeat to turn back on.
Timed Cooking
To Turn Tones Off/On: Touch and hold COOK TIME until a tone
sounds and the lower oven display returns to inactive mode
(blank). Repeat to turn back on.