Filter
Top Products
NOTE: Do NOT plug power supply cord into outlet.
4
. Lay spout assembly on flat
Slide gasket over tubing so that lip
surface with coiled tubing facing up.
side of gasket is seated into base of
Using one hand to hold tubing just
spout.
below spout, carefully straighten
tubing with other hand.
5
.Loosen square nut until it is
Hold nut, bracket, gasket and tubing
flush with end of the mounting screw.
in position and insert into hole in sink
Tip spout bracket against mounting
or counter.
screw. (Bracket will form a “y” when
in the correct position.)
6
n Pull up on spout body to keep
tension on spout mounting bracket
and nut. Tighten screw inside the
spout until spout is securely in
position. Do not overtighten. Snap
on On/Off Cap.
7
. Position tank vertically beneath
Position mounting bracket on wall so
spout so that clear tubing from spout
that bottom of mounting bracket is
reaches center stainless tubing on
even with the lower line. Use two
tank, and tank touches wall. Use a
screws (and plastic anchors if
pencil to mark on the wall where the
attaching to dry wall) to fasten
top of tank needs to be located. Set
mounting bracket to wall. Hang tank
tank aside. Mark a second line 2-l/4”
on bracket.
below the first line.