Filter
Top Products
water supply
line
\
quick-connect
\ fitting
.
13
.Connect water supplv line
from saddle valve to spout’copper
tubing with the factory-assembled
quick-connect fitting. Push water
supply line tubing straight into fitting
as far as it will go. Pull on tubing.
The tubing should not come out
when properly installed. Turn the
saddle valve handle counterclockwise C
to open water line.
NOTE: If you need to remove tubing,
push down on collet. Pull tubing out
of quick-connect fitting.
NOTE: Do NOT plug power supply cord into outlet.
14
n Turn Temperature Control
counterclockwise to “Off” position.
15
.Turn the On/Off Cap
clockwise to open spout. Hold cap
open to fill tank (about 1 minute).
When tank is full, water will flow from
spout. Release cap.
16
. Plug power supply cord into
grounded outlet.
Turn Temperature Control clockwise
to highest position.
Water in tank will reach maximum
temperature in approximately
15 minutes.
When water is heating, you may hear
gurgling noises coming from the tank.
There may also be some spitting or
hot water flow from the faucet. This is
normal for the initial heat-up of the
dispenser.
Turn Temperature Control to lower
temperature setting if you notice
vapor or hear boiling noise.
NOTE: Temperature Control
controls tank heater, not water
delivery. Rotate Temperature
Control clockwise to raise water
temperature, counterclockwise to
lower water temperature.
~.~,~~
+ >.*
. r*h x.,,,x.x.-~.v