Filter
Top Products
NOTE: Do NOT plug power supply cord into outlet.
8
.Connect l/4” spout tubing
NOTE: If you need to remove tubing,
(longer tubing) to the rear quick-
push down on collet. Pull tubing out
connect fitting on top of tank. Push
of quick-connect fitting.
tubing straight into fitting as far as it
will go. Pull on tubing. The tubing
should not come out when properly
installed.
Do Not lengthen, twist or tightly
bend tubing.
9
.Connect clear tubing from spout
to center tank tubing using clamp.
Make sure clear tubing does not kink.
10
. Install saddle valve following Drill a l/4” hole into water supply line
kit instructions. If water supply line is
for the saddle valve piercing pin.
not copper, shut off water supply and
drain line.
11
HTurn saddle valve handle Place a bucket under open end of
clockwise r) until lance pierces soft
water supply line. Turn on main water
copper tubing and valve is firmly
supply valve to pressurize cold water
seated. If the water line is not copper,
line. Check for leaks.
turn the saddle valve handle
clockwise until the valve is firmly
seated. The valve is now in the
closed position.
12
,Slowly open saddle valve and
flush line into bucket to remove any
foreign material that may have been
trapped in the supply line during
saddle valve installation.
Close saddle valve.