Filter
Top Products
Number Pads
Fan and light Pads
Once you’ve touched a Command Pad to tell
the oven what you want It to do, you’ll touch
Number Pads to tell it...
- a time.
The six pads at the bottom of the control panel
control the 2-Speed Exhaust Fan and the
Cooktop Light.
Touch Fan Pad for the deslred fan speed.
(NOTE: If the temperature gets too hot around
the mlcrowave oven, the exhaust fan In the
vent hood will automatically turn on the l.CW
sefflng to protect the oven. lt may stay on up
to an hour to cool the oven. When thls occurs,
the Fan Pad will not turn the fan off.)
- a Cook Power.
- a food temperature.
Audible Signals
Touch Light Pad for the desired cooktop or
countertop lighting.
Audible signals are available to guide you when setting and using your oven. (A programming tone will
sound each time you touch a pad. Four beeps signal the end of a Cook or Defrost cycle. Two beeps will
sound between cycles. A reminder tone will sound every 60 seconds after cooking is done to remlnd you
that something has been left In the oven. A 3 second tone signals the end of the Minute Timer functton.) If you
don’t hear a tone, it is because of incorrectly entered instructions or because the tones have been removed.
For example, a tone will not sound if you touch a Number Pad before you touch a Command Pad.
To remove the programmlng tone and reminder
tone (the Mlnute Timer slgnal will not be
removed]:
l Open the door.
l Touch CANCEL twice, then touch START.
l Programming and reminder tones will be
cancelled.
To replace the tones:
l Repeat the steps above.
NOTE: If your electricity goes ofl,the tones will be replaced when the electrlclty comes back on.
Setting the Clock
When the oven is first plugged in, a tone sounds and the Display shows “88:88:’ If the
electric power ever goes off, the Display will again show all 8’s when the power comes
back on.
You can cook or use the Minute Timer without setting the Clock, but the Display will be
blank after cooking.
DO THIS...
THIS HAPPENS...
:h CLOCK SET.
6