Filter
Top Products
Using Your Microwave Oven
Microwave oven controls
There are three parts in the control section:
- Display/Clock and indicators
-Command Pads
-Number Pads
instructions for each control are covered on the
following
pages.
Read them carefully.
When you first plug in the oven, the Display will
flash 88:88. Touch STOP/CLEAR and “1 :OO” will
appear. ff, after you set the Clock (page 1 l), the
Display again shows all 8’s, it means your
electricity was off for a while. Reset the Clock.
Display/clock and indicators
When you are not using the microwave oven, this
is an accurate clock.
When you are using the microwave oven, it
displays time settings, cook powers, and
indicators.
Command pads
l
Touch Command Pads to tell the microwave
oven what to do and in what order. A few
examples:
-CLOCK tells the oven you are going to set the
clock.
-START tells the oven to start.
l
Each Command Pad (except START, STOP/
CLEAR, AUTO START/CLOCK and TIMER/
PAUSE) causes an indicator to light when you
touch the Command Pad. While the oven is
running, an indicator (or indicators) will be on to
show what the oven is doing.
l
ff you touch two instructions into the same
cycle, the second set of instructions will cancel
the first.
Number pads
Once you’ve touched
a
Command Pad to tell the
oven what you
want
it to do, you’ll touch Number
Pads to tell it . . .
-a time,
-a Cook Power.
Display messages
Messages
will appear on the display to guide you
with your cooking. If you attempt to enter
unacceptable instructions, “ERROR” will appear
in the Display. Touch STOP/CLEAR and re-enter
the instructions.
10