Filter
Top Products
Using your microwave oven
Microwave oven controls
There are three parts In the control section
-The Dtgital DlsplayiClock. and Signal
Lights
-Command Pads
-Number Pads
What each of these does will be covered on
the following pages. Read them carefully
When you first plug in the oven, a tone sounds
and the Display will be blank. If after you set the
Clock (page 9), the Display becomes blank
again, it means your electricity was off for a
while. Reset the Clock.
Digital display/clock and signal lights
and shows you what
number pads you
touched.
Command pads
--a:
m
.
.
q
Touch Command
Pads to tell the
microwave oven
what to do and in
what order. A few
examples:
-CLOCK SET tells
the oven you are
going to set the
mm -STARTtellsthe
clock.
oven to start. See
page 21 for information on the tone you hear
when touching any pad.
Each Command Pad lights a Signal Light
[except START and CANCEL). The Signal Light
comes on when you touch the Command
Pad.
While the oven is running, a Signal Light
(or lights) will be on to show what the oven
is doing.
Number pads