Filter
Top Products
Audible signals
Audible signals are available to guide you when setting and using your oven. (A programming tone
will sound each time you touch a pad. Two beeps will sound between cycles. A reminder tone will
sound every 30 seconds after cooking is done to remind you that something has been left in the
oven. A 4 beep sound signals the end of the Minute Timer function.) If you don’t hear a tone, it is
because of incorrectly entered instructions or because the tones have been removed. For example,
a tone wilt not sound if you touch a Number Pad before you touch a Command Pad.
To remove the programming tone:
To remove all tones:
* Open the door.
l
Open the door.
* Touch CANCEL twice, then touch START.
l
Touch CANCEL twice, touch 0, then touch START.
* Programming and reminder tones will be
l
All audible tones (including minute timer sig-
cancelled.
nal) will be cancelled.
NOTE: Do not remove all tones if you use the
To replace the tones:
Minute Timer.
* Repeat the steps above.
To replace the tones:
l
Repeat the steps above.
NOTE: If your electrlcfty goes off, the audible signals wlii come back on. Repeat steps
above If you want to remove them agaln.
Setting the clock
When the oven is first plugged in, one beep will sound and the Display shows 88:88. If the
electric power ever goes off, the Display will again show all 8’s when the power comes
back on.
You can cook without setting the clock, but the Display wilt be blank after cooking.
DO THIS...
THIS HAPPENS...
The Display will show a “0” and
the colon will start to flash. The
first Number Pad must be touched
wlthln 5 seconds or the Display will
go blank. Touch CLOCK SET again
and continue.
2. Touch Number Pads tor the
correct time of day.
The Display will show what numbers
you touched in the order you
touched them. This example shows
3:25.
3.
Touch START.
The colon will stop flashing. The Clock
is set.
If you have touched in an incorrect
time, such as 12~55, “Err” will show on
the Display Touch CLOCK SET and
start over.
NOTE: To reset the clock, touch CLOCK SET. The current time will show on the Display
and the colon will flash. Contlnue to set the clock as shown above.