Filter
Top Products
When the cooking time ends, “End”
will show on the Display and 4
beeps will sound. (You can stop the
beeping by opening the door or by
touching CANCEL.) “End” will remain
on the Display and a reminder tone
will sound every 30 seconds until
the door is opened or CANCEL is
touched. The Display will then show
the time of day.
Note: If the oven light and fan come
on when you touch START, the Start
Time has not been set correctly.
Open and close door, reprogram
AUTO START time, then touch START.
Additional information
l
Additional cycles can be set when using AUTO START. Follow instmctions under the
proper heading (Using AUTO SENSOR, Defrosting, Using KEEP WARM] either before or
after you touch START.
l
You can change times, or add cycles at any time during the AUTO START cycle.
1. Touch the COOK Cycle you wish to change or add.
2. Touch numbers for new time.
3. Touch COOK POWER, if desired.
4. Touch number for new Cook Power, or touch COOK POWER again if high is desired
5. Touch START.
l
Opening the door does not stop Auto Start operation.
CAUTION:
Use foods that will not go bad or spoil while waiting for cooking to start. Avoid using with milk or
eggs, cream soups, cooked meats, poultry or fish, or any item with baking powder or yeast.
Smoked or frozen meats may be used; so can vegetables, fruits and casserole-type foods.
Any food that has to wait for cooking to start should be very cold or frozen before it is put in the
oven, MOST UNFROZEN FOODS SHOULD NEVER STAND AT ROOM TEMPERATURE MORE THAN TWO
HOURS BEFORE COOKING STARTS.
Other operating hints
1. To double check settings while the oven is running:
l
Touch the Command Pad for the setting you want to check. The instruction
programmed for that pad will show on the display for 5 seconds. Then the display
returns to showing what the oven is doing.
2. To stop the oven while it is running:
l
Open the door. The oven will stop. Restart the oven by closing the door and touching
START.
l
Touch CANCEL. All instructions will be erased. You must touch in new instructions.
3.
l
If you touch two instructions into the same cycle, the second set of instructions will
cancel the first.